Saw & Shear for Rolling Mill

FLYING DIVIDING SHEAR

To cut TMT Bar as per Cooling Bed Length. Our Fly shear can cut up to a finishing speed of 20mps.

CONTINUOUS SHEAR

To cut TMT Bar as per Cooling Bed Length at higher finishing speeds.

END CUTTING CROP AND COBBLE SHEAR

These shears are used to cut the front end and tail end and for segment cutting in case of eventualities in hot rolling. They are controlled through a PLC system and give very near tolerance to the cropped length. They are start/stop type which is driven using either Direct DC motor or with Flywheel mounted Pneumatic Clutch/Brake.

COLD SHEAR (HYDRAULIC, ELECTRO-MECHANICAL, PNEUMATIC CLUTCH & BRAKE-TYPE)

Cold shear is located right after the cooling bed. These are designed to cut metals using their high strength capacity, produced in various shapes, sizes, and sections. Cold shears can be designed and manufactured for any particular customized requirements. They cut the Bars into Market lengths.

– Pneumatic Clutch Brake Type Cold Shear
– Hydraulic Cold Shear
– Electro-Mechanical Cold Shear

HOT SAW AND COLD SAW

Hot saws are used in hot rolling for cropping the structural section in the required length as well as for cropping front and rear ends. There are two kinds of hot saws – Horizontal shift type and static type.

The cold saw provides extremely precise cutting, whereby both open and closed types are available. They are available with start and stop drive, handling structural sections, and high alloy steels.